Brenna 23" Spiral Curl Banana Clip Hairpiece - Attachment Instructions

There are 2 methods with which to attach theBrenna hairpiece.

Method 1-Looks like a long ponytail.

Step 1		Step 2		Step 3		Step 4
Brush the hair back off the face and secure it at the top of the head with a rubber band. This forms an anchor for the hairpiece's Banana Clip attachment.		Brush the middle section of hair back to the center of the head and secure it with a second rubber band underneath the first.		Brush the remaining hair back and secure it with a rubber band at the nape of the neck.		Pull the right side of the remaining pony tail section of hair (at the nape of the neck) straight up and secure it under the upper pony tail section with bobby pins so that the hair is as flat to the back of the head as possible.
Step 5		Step 6		Step 7
Pull the left side of the remaining pony tail section of hair (at the nape of the neck) straight up and secure it under the upper pony tail section with bobby pins so that the hair is as flat to the back of the head as possible, as you did with the right.		Unsnap the top and bottom snaps of the banana clip and lay the hairpiece out flat. Notice where the tag is located. This is the bottom of the hairpiece and should be placed near the neck when secured to the head.		When you have correctly identified the top and bottom of the hairpiece, place the hairpiece over the ponytails running down the back center of the head. Press each side of the banana combs into and under the ponytails. Then snap the top of the banana clip over the top ponytail anchor, and the bottom of the banana clip under the bottom ponytail anchor. This entire process should take about five minutes. It's that easy!

Method 2 - Provides a fuller, full head effect across the back of the head.

Step 1		Step 2		Step 3		Step 4
Split the hair into two sections down the middle of the head. Start with the top, left section and brush the hair back securing it at the left crown of the head with a rubberband.		Do the same with the hair on the right. These two ponytails will serve as the top anchors for the banana clip combs.		Brush back the middle sections of hair on the left and right sides, securing them with rubberbands beneath the top two ponytails. These will serve as middle anchors for the banana clip combs.		Brush back the remaining left and right sections of hair and secure them with rubberbands underneath the other ponytails. These are your bottom anchors.
Step 5		Step 6		Step 7		Step 8
Pull the right ponytail at the nape of the neck to the left side and bobby pin it to the head as flat as possible.		Do the same with the left ponytail, pulling it to the right side of the head and bobby pinning it flat.		Unsnap the top and bottom snaps of the banana clip and lay the hairpiece out flat. Notice where the tag is located. This is the bottom of the hairpiece and should be placed near the neck when secured to the head.		When you have correctly identified the top and bottom of the hairpiece, place the hairpiece on the outsides of the ponytails running down both sides of the head. Press each side of the banana combs into and under the ponytails. With this method, there is no need to snap the top and bottom of the banana clip. The combs pressed into the ponytail anchors will be very strong and secure. This entire process should take about five minutes. It's that easy!